How to Jumpstart a 2014 Jeep Wrangler Sport 3.6L V6

Jeep Wrangler Model Years - 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017

How to properly jump start a car with the correct cable order

Author

Hans Angermeier is an ASE certified Maintenance and Light Repair Technician and has produced over 100,000 videos showing drivers how to fix things on their cars. He has broad expertise on basic repair procedures covering the majority of cars on the road. Over the past 10 years, Hans has been focused on building CarCareKiosk, which is visited by millions of drivers each month.

2014 Jeep Wrangler Sport 3.6L V6 Lights Turn Signal - Front (replace bulb)

If your blinker doesn't blink, or blinks rapidly, you likely have a burnt out bulb

2014 Jeep Wrangler Sport 3.6L V6 Air Conditioner Recharge Freon

If your car blows hot air when your air conditioner is turned on, try recharging the freon first

2014 Jeep Wrangler Sport 3.6L V6 Lights Center Brake Light (replace bulb)

Don't be the guy with your third brake light burnt out

2014 Jeep Wrangler Sport 3.6L V6 Clock Set Clock

Is the clock in your car ahead or behind? Learn how to set it here!

Share on   Share on Twitter   Share on Facebook
Parts & Tools
We may earn a commission from qualifying purchases as an Amazon Associate
Video Description

This video shows you how to use jumper cables to jump start a dead battery in your 2014 Jeep Wrangler. If you get into your Wrangler, turn the key, and your car doesn't start (you may hear nothing or a clicking sound from the engine bay), you have a dead battery and need a jump-start. Check to see if you left your headlights or an interior light on and turn the switch off. Assuming that you have a pair of jumper cables, a pair of safety glasses and a friend to give you a jumpstart, the video above will show you where to connect the cables (and in what order!) for your Wrangler.

It is important to use the best jumper cables you can buy as they have thicker gauge (0, 2 or 4 gauge) wire and will impact how long to charge car battery with jumper cables (your Wrangler will charge faster with thicker cables). Cheap jumper cables have very thin wire such as 8 or 10 gauge), which increases how long it will take to charge the battery with jumper cables in your Wrangler. When you finish jumpstarting the dead battery car, which battery terminal to disconnect first is important. Be sure to disconnect the negative cable (black cable) from the ground on the dead car, then disconnect the negative cable from the ground on the donor battery, then disconnect the positive (red cable) from the donor battery and finally disconnect the positive cable from the dead car. Once you are finished reviving a dead car battery in your Wrangler, make sure you drive it for at least 5 minutes before turning it off so your battery isn't dead the next time.

So what's up with the safety glasses? There is a small possibility of a battery exploding during the charging process if you don't connect the cables properly (causing a spark) and there is a bunch of hydrogen gas around the battery (car batteries emit hydrogen gas when they discharge) - this is much more of an issue with cars that haven't been driven for a long time than if you drive your Wrangler regularly and simply forgot to turn your lights off.

  • Advance Auto coupon for
    20% off entire order: KIOSK20